Average Well Color Development (AWCD) data based on Community Level Physiological Profiling (CLPP) of soil samples from 120 point locations within limestone cedar glades at Stones River National Battlefield near Murfreesboro, Tennessee

Dates

Publication Date: 2013-12-09
Start Date: 2012-02-06
End Date: 2013-03-19

Citation

Cartwright, J.M., 2015, Average Well Color Development (AWCD) data based on Community Level Physiological Profiling (CLPP) of soil samples from 120 point locations within limestone cedar glades at Stones River National Battlefield near Murfreesboro, Tennessee: U.S. Geological Survey data release, http://dx.doi.org/10.5066/F7NV9G9C.

Summary

This dataset contains data collected within limestone cedar glades at Stones River National Battlefield (STRI) near Murfreesboro, Tennessee. This dataset contains information on soil microbial metabolic response for soil samples obtained from certain quadrat locations (points) within 12 selected cedar glades. This information derives from substrate utilization profiles based on Biolog EcoPlates (Biolog, Inc., Hayward, CA, USA) which were inoculated with soil slurries containing the entire microbial community present in each soil sample. EcoPlates contain 31 sole-carbon substrates (present in triplicate on each plate) and one blank (control) well. Once the microbial community from a soil sample is inoculated onto the plates, the plates [...]

Summary

This dataset contains data collected within limestone cedar glades at Stones River National Battlefield (STRI) near Murfreesboro, Tennessee. This dataset contains information on soil microbial metabolic response for soil samples obtained from certain quadrat locations (points) within 12 selected cedar glades. This information derives from substrate utilization profiles based on Biolog EcoPlates (Biolog, Inc., Hayward, CA, USA) which were inoculated with soil slurries containing the entire microbial community present in each soil sample. EcoPlates contain 31 sole-carbon substrates (present in triplicate on each plate) and one blank (control) well. Once the microbial community from a soil sample is inoculated onto the plates, the plates are incubated and absorbance readings are taken at intervals.For each quadrat location (point), one soil sample was obtained under sterile conditions, using a trowel wiped with methanol and rinsed with distilled water, and was placed into an autoclaved jar with a tight-fitting lid and placed on ice. Soil samples were transported to lab facilities on ice and immediately refrigerated. Within 24 hours after being removed from the field, soil samples were processed for community level physiological profiling (CLPP) using Biolog EcoPlates. First, for each soil sample three measurements were taken of gravimetric soil water content using a Mettler Toledo HB43 halogen moisture analyzer (Mettler Toledo, Columbus, OH, USA) and the mean of these three SWC measurements was used to calculate the 10-gram dry weight equivalent (DWE) for each soil sample. For each soil sample, a 10-gram DWE of fresh soil was added to 90 milliliters of sterile buffer solution in a 125-milliliter plastic bottle to make the first dilution. Bottles were agitated on a wrist-action shaker for 20 minutes, and a 10-milliliter aliquot was taken from each sample using sterilized pipette tips and added to 90 milliliters of sterile buffer solution to make the second dilution. The bottle containing the second dilution for each sample was agitated for 10 seconds by hand, poured into a sterile tray, and the second dilution was inoculated directly onto Biolog EcoPlates using a sterilized pipette set to deliver 150 microliters into each well. Each plate was immediately covered, placed in a covered box and incubated in the dark at 25 degrees Celcius. Catabolism of each carbon substrate produced a proportional color change response (from the color of the inoculant to dark purple) due to the activity of the redox dye tetrazolium violot (present in all wells including blanks). Plates were read at intervals of 24 hours, 48 hours, 72 hours, 96 hours and 120 hours after inoculation using a Biolog MicroStation plate reader (Biolog, Inc., Hayward, CA, USA) reading absorbance at 590 nanometers.For each soil sample and at each incubation time point, average well color development (AWCD) was calculated according to the equation:AWCD = [Σ (C – R)] / n where C represents the absorbance value of control wells (mean of 3 controls), R is the mean absorbance of the response wells (3 wells per carbon substrate), and n is the number of carbon substrates (31 for EcoPlates). For each soil sample, an incubation curve was constructed using AWCD values from 48 hours to 120 hours, and the area under this incubation curve was calculated. The numeric values contained in the fields of this dataset represent areas under these AWCD incubation curves from 48 hours to 120 hours. Detailed descriptions of experimental design, field data collection procedures, laboratory procedures, and data analysis are presented in Cartwright (2014).

References:
Cartwright, J. (2014). Soil ecology of a rock outcrop ecosystem: abiotic stresses, soil respiration, and microbial community profiles in limestone cedar glades. Ph.D. dissertation, Tennessee State University.
Cofer, M., Walck, J., and Hidayati, S. (2008). Species richness and exotic species invasion in Middle Tennessee cedar glades in relation to abiotic and biotic factors. The Journal of the Torrey Botanical Society, 135(4), 540–553.
Garland, J., & Mills, A. (1991). Classification and characterization of heterotrophic microbial communities on the basis of patterns of community-level sole-carbon-source utilization. Applied and environmental microbiology, 57(8), 2351–2359.
Garland, J. (1997). Analysis and interpretation of community‐level physiological profiles in microbial ecology. FEMS Microbiology Ecology, 24, 289–300.
Hackett, C. A., & Griffiths, B. S. (1997). Statistical analysis of the time-course of Biolog substrate utilization. Journal of Microbiological Methods, 30(1), 63–69.Insam, H. (1997). A new set of substrates proposed for community characterization in environmental samples. In H. Insam & A. Rangger (Eds.), Microbial Communities: Functional versus Structural Approaches(pp. 259–260). New York: Springer.
Preston-Mafham, J., Boddy, L., & Randerson, P. F. (2002). Analysis of microbial community functional diversity using sole-carbon-source utilisation profiles - a critique. FEMS microbiology ecology, 42(1), 1–14. doi:10.1111/j.1574-6941.2002.tb00990.x

Contacts

Point of Contact :: U.S. Geological Survey Tennessee Water Science Center (TNWSC)
Distributor :: U.S. Geological Survey - ScienceBase
Metadata Contact :: U.S. Geological Survey Tennessee Water Science Center (TNWSC)
Originator :: U.S. Geological Survey, Lower Mississippi and Gulf Water Science Center, Jennifer Cartwright

Attached Files

sorting

Metadata First

Recent First

Alphabetical

Click on title to download individual files attached to this item.

STRI_glades_soil_CLPP_AWCD_metadata.xml Original FGDC Metadata	View	33.31 KB	application/fgdc+xml

Shapefile: STRI_glades_soil_CLPP_AWCD.zip
STRI_glades_soil_CLPP_AWCD.shp		1.08 KB
STRI_glades_soil_CLPP_AWCD.dbf		10.79 KB
STRI_glades_soil_CLPP_AWCD.shx		388 Bytes
STRI_glades_soil_CLPP_AWCD.prj		424 Bytes
STRI_glades_soil_CLPP_AWCD.shp.xml		4.16 MB
STRI_glades_soil_CLPP_AWCD.sbn		484 Bytes
STRI_glades_soil_CLPP_AWCD.sbx		140 Bytes

Purpose

This dataset was developed by the U.S. Geological Survey Tennessee Water Science Center (TNWSC) in partnership with the National Park Service staff at Stones River National Battlefield (STRI) for the purpose of characterizing seasonal patterns of soil microbial metabolic response for a subset of limestone cedar glades present within STRI.

Average Well Color Development (AWCD) data based on Community Level Physiological Profiling (CLPP) of soil samples from 120 point locations within limestone cedar glades at Stones River National Battlefield near Murfreesboro, Tennessee

Dates

Citation

Summary

Summary

Contacts

Attached Files

sorting

Metadata First

Recent First

Alphabetical

Purpose

Map

Spatial Services

Communities

Tags

Provenance

Additional Information

Shapefile Extension

Citation Extension

Item Actions

Use Item

View Item as ...

Save Item as ...

View Item...

Dates

Citation

Summary

Summary

Contacts

Attached Files sorting Metadata First Recent First Alphabetical

Purpose

Map

Spatial Services

Communities

Tags

Provenance

Additional Information

Shapefile Extension

Citation Extension

Item Actions

Use Item

View Item as ...

Save Item as ...

View Item...

Attached Files

sorting

Metadata First

Recent First

Alphabetical