Filters: Tags: Illinois basin (X)
12 results (22ms)|
Filters
Date Range
Extensions Types Contacts
Categories Tag Types Tag Schemes |
Inductively coupled plasma - optical emission spectrometry (ICP-OES) analysis data compiled using sample preparation procedures outlined by ASTM D2013/D2013M-18 and ASTM D6357, and using two independent sets of element standards for instrument calibration. Additional analysis methodologies are described in detail in the resulting publication Rare earth elements and yttrium in Pennsylvanian coals and shales in the eastern part of the Illinois Basin (Mastalerz et al., 2020).
Categories: Data;
Types: Data,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
OGC WMS Service;
Tags: Brazil Formation,
Coal,
Coal Ash,
Dugger Formation,
Illinois Basin,
The USGS Central Region Energy Team assesses oil and gas resources of the United States. The onshore and State water areas of the United States comprise 71 provinces. Within these provinces, hydrocarbon plays were defined and assessed. Each of these provinces is defined geologically, and most province boundaries are defined by major geologic changes. The province boundaries were drawn on the county lines that most closely followed the natural geologic boundaries.
Categories: Data;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: Adirondack Uplift,
Albuquerque - Santa Fe Rift,
Anadarko Basin,
Appalachian Basin,
Arkoma Basin,
Idealized, basin-scale sharp-interface models of CO2 injection were constructed for the Illinois basin. Porosity and permeability were decreased with depth within the Mount Simon Formation. Eau Claire confining unit porosity and permeability were kept fixed. We used 726 injection wells located near 42 power plants to deliver 80 million metric tons of CO2/year. After 100 years of continuous injection, deviatoric fluid pressures varied between 5.6 and 18 MPa across central and southern part of the Illinois basin. Maximum deviatoric pressure reached about 50% of lithostatic levels to the south. The pressure disturbance (>0.03 MPa) propagated 10-25 km away from the injection wells resulting in significant well-well...
Categories: Publication;
Types: Citation;
Tags: Brine transport,
CO2,
Earthquakes,
Illinois basin,
Mount Simon,
These geospatial data and their accompanying report outline many areas of coal in the United States beneath more than 3,000 ft of overburden. Based on depth, these areas may be targets for injection and storage of supercritical carbon dioxide. Additional areas where coal exists beneath more than 1,000 ft of overburden are also outlined; these may be targets for geologic storage of carbon dioxide in conjunction with enhanced coalbed methane production. These areas of deep coal were compiled as polygons into a shapefile for use in a geographic information system (GIS). The coal-bearing formation names, coal basin or field names, geographic provinces, coal ranks, coal geologic ages, and estimated individual coalbed...
We developed a methodology to estimate maximum brine injection rates in subsurface formations across wide geographic areas using inverse modeling-based optimization techniques. We first defined geographic areas where groundwater was too saline to meet the standard for drinking water and where sufficient confining units existed above and below the injection layers. We then assumed concurrent brine injection into a system of wells on a consistent 25 km x 25 km spacing across the entire modeled area. Taking advantage of symmetry, we represented each 25 km x 25 km injection area as a 12.5 km-long one-dimensional radial model, divided into 100 logarithmically-sized grid blocks. A single layer of grid blocks was used...
Cell maps for each oil and gas assessment unit were created by the USGS to illustrate the degree of exploration, type of production, and distribution of production in an assessment unit or province. Each cell represents a quarter-mile square of the land surface, and the cells were then coded to indicate whether the wells included within the cell are predominantly oil-producing, gas-producing, are both oil- and gas-producing , or are dry or the type of production is unknown.. The well information was initially retrieved from the IHS Energy Group, PI/Dwights PLUS Well Data on CD-ROM, which is a proprietary, commercial database containing information for most oil and gas wells in the U.S. Cells were developed as a...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 506401 = Precambrian to Cambrian,
50640101 = Precambrian to Cambrian Rift-Fill,
50640102 = Cambrian Mount Simon to Eau Claire,
50640103 = Cambrian to Ordovician Knox Group,
506402 = Ordovician Ancell Maquoketa,
The Assessment Unit is the fundamental unit used in the National Assessment Project for the assessment of undiscovered oil and gas resources. The Assessment Unit is defined within the context of the higher-level Total Petroleum System. The Assessment Unit is shown here as a geographic boundary interpreted, defined, and mapped by the geologist responsible for the province and incorporates a set of known or postulated oil and (or) gas accumulations sharing similar geologic, geographic, and temporal properties within the Total Petroleum System, such as source rock, timing, migration pathways, trapping mechanism, and hydrocarbon type. The Assessment Unit boundary is defined geologically as the limits of the geologic...
The Total Petroleum System is used in the National Assessment Project and incorporates the Assessment Unit, which is the fundamental geologic unit used for the assessment of undiscovered oil and gas resources. The Total Petroleum System is shown here as a geographic boundary defined and mapped by the geologist responsible for the province and incorporates not only the set of known or postulated oil and (or) gas accumulations, but also the geologic interpretation of the essential elements and processes within the petroleum system that relate to source, generation, migration, accumulation, and trapping of the discovered and undiscovered petroleum resource(s).
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 506401 = Precambrian to Cambrian,
50640101 = Precambrian to Cambrian Rift-Fill,
50640102 = Cambrian Mount Simon to Eau Claire,
50640103 = Cambrian to Ordovician Knox Group,
506402 = Ordovician Ancell Maquoketa,
Idealized, basin-scale sharp-interface models of CO2 injection were constructed for the Illinois basin. Porosity and permeability were decreased with depth within the Mount Simon Formation. Eau Claire confining unit porosity and permeability were kept fixed. We used 726 injection wells located near 42 power plants to deliver 80 million metric tons of CO2/year. After 100 years of continuous injection, deviatoric fluid pressures varied between 5.6 and 18 MPa across central and southern part of the Illinois basin. Maximum deviatoric pressure reached about 50% of lithostatic levels to the south. The pressure disturbance (>0.03 MPa) propagated 10-25 km away from the injection wells resulting in significant well-well...
Categories: Publication;
Types: Citation;
Tags: Brine transport,
CO2,
Earthquakes,
Illinois basin,
Mount Simon,
This digital data release presents contour data from multiple subsurface geologic horizons as presented in previously published summaries of the regional subsurface configuration of the Michigan and Illinois Basins. The original maps that served as the source of the digital data within this geodatabase are from the Geological Society of America’s Decade of North American Geology project series, “The Geology of North America” volume D-2, chapter 13 “The Michigan Basin” and chapter 14 “Illinois Basin Region”. Contour maps in the original published chapters were generated from geophysical well logs (generally gamma-ray) and adapted from previously published contour maps. The published contour maps illustrated the distribution...
The USGS Central Region Energy Team assesses oil and gas resources of the United States. The onshore and State water areas of the United States comprise 71 provinces. Within these provinces, Total Petroleum Systems are defined and Assessment Units are defined and assessed. Each of these provinces is defined geologically, and most province boundaries are defined by major geologic changes. The Illinois Basin Province is located in portions of Kentucky, Illinois, Indiana, Missouri, and Tennessee. The main population centers within the study area are Louisville, Kentucky; Peoria and Springfield Illinois; Indianapolis, Indiana; Saint Louis, Missouri; and Nashville, Tennessee. The main interstates, I-80, I-70, and I-40,...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 506401 = Precambrian to Cambrian,
50640101 = Precambrian to Cambrian Rift-Fill,
50640102 = Cambrian Mount Simon to Eau Claire,
50640103 = Cambrian to Ordovician Knox Group,
506402 = Ordovician Ancell Maquoketa,
The USGS Central Region Energy Team assesses oil and gas resources of the United States. The onshore and State water areas of the United States comprise 71 provinces. Within these provinces, Total Petroleum Systems are defined and Assessment Units are defined and assessed. Each of province is defined geologically, and most province boundaries are defined by major geologic changes. This dataset is a compilation of data that has been studied and published separately, and in some cases adjacent provinces do not share a common boundary. As a consequence, there are numerous gaps and overlaps in this layer.
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: Adirondack Uplift,
Albuquerque - Santa Fe Rift,
Anadarko Basin,
Appalachian Basin,
Arkoma Basin,
|
|
