Filters: Tags: US12 (X) > partyWithName: U.S. Geological Survey - ScienceBase (X)
12 results (39ms)|
Filters
Date Range
Extensions Types Contacts
Categories Tag Types Tag Schemes |
The maximum extent of Cretaceous onlap is generalized from Plate 3, Structure at the base and subcrop below Mesozoic marine section, Gulf of Mexico Basin (compiled by A. Salvador) in Volume J, The Geology of North America (1991). This dataset contains basic data and interpretations developed and compiled by the U.S. Geological Survey's Framework Studies and Assessment of the Gulf Coast Project. Other major sources of data include publicly available information from state agencies as well as publications of the U.S. Geological Survey and other scientific organizations. In cases where company proprietary data were used to produce various derivatives such as contour surfaces, the source is cited but the data are not...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 47 = Western Gulf,
48 = East Texas Basin,
49 = Louisiana-Mississippi Salt Basins,
50 = Florida Peninsula,
AL,
This map shows the structural configuration on the top of the Cotton Valley Group in feet below sea level. The map was produced by calculating the difference between a datum at the land surface (either the kelly bushing elevation or the ground surface elevation) and the reported depth of the Cotton Valley Group. This resulted in 10,687 wells for which locations were available. After deleting the wells with obvious data problems, a total of 10,504 wells were used to generate the map. The data are provided as both lines and polygons, and the proprietary wells that penetrate the top of the Cotton Valley Group are graphically displayed as quarter-mile cells. The well information was initially retrieved from the IHS...
The USGS Central Region Energy Team assesses oil and gas resources of the United States. The onshore and State water areas of the United States comprise 71 provinces. Within these provinces, hydrocarbon plays or assessment units are defined and assessed. Each of these provinces is defined geologically, and most province boundaries are defined by major geologic changes. The province boundaries were drawn on the county lines that most closely followed the natural geologic boundaries.
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 47 = Western Gulf,
48 = East Texas Basin,
49 = Louisiana-Mississippi Salt Basins,
50 = Florida Peninsula,
AL,
This map shows the structural configuration of the top of the Travis Peak or Hosston Formations in feet below sea level. The map was produced by calculating the difference between a datum at the land surface (either the Kelly bushing elevation or the ground surface elevation) and the reported depth of the Travis Peak or Hosston. This resulted in 18,941 wells for which locations were available. After deleting the wells with obvious data problems, a total of 18,933 wells were used for the map. The data are provided as both lines and polygons, and the proprietary wells that penetrate the top of the Travis Peak or Hosston Formations are graphically displayed as quarter-mile cells. The well information was initially...
Cell maps for each oil and gas assessment unit were created by the USGS as a method for illustrating the degree of exploration, type of production, and distribution of production in an assessment unit or province. Each cell represents a quarter-mile square of the land surface, and the cells are coded to represent whether the wells included within the cell are predominantly oil-producing, gas-producing, both oil and gas-producing, dry, or the type of production of the wells located within the cell is unknown. The well information was initially retrieved from the IHS Energy Group, PI/Dwights PLUS Well Data on CD-ROM, which is a proprietary, commercial database containing information for most oil and gas wells in the...
The Positive Structural Elements coverage maps, in the form of polygons, are known structural highs within the province that commonly define a basin proper or influence the occurrence of discovered or undiscovered hydrocarbon accumulations. Positive Structural Elements are shown here as geographic polygons that were only generally defined and mapped by the geologist responsible for the province. These Positive Structural Elements were mapped mostly from other resources, including previously published maps and literature (see Pollastro and Viger, 1998, in text portion of publication DDS-69-A). The Positive Structural Elements boundaries were defined in the period from March to May, 2000.
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: Coalbed methane resources,
Earth Science,
Economic geology,
Energy Resources,
FL,
The Assessment Unit is the fundamental unit used in the National Assessment Project for the assessment of undiscovered oil and gas resources. The Assessment Unit is defined within the context of the higher-level Total Petroleum System. The Assessment Unit is shown here as a geographic boundary interpreted, defined, and mapped by the geologist responsible for the province and incorporates a set of known or postulated oil and (or) gas accumulations sharing similar geologic, geographic, and temporal properties within the Total Petroleum System, such as source rock, timing, migration pathways, trapping mechanism, and hydrocarbon type. The Assessment Unit boundary is defined geologically as the limits of the geologic...
The Total Petroleum System is used in the National Assessment Project and incorporates the Assessment Unit, which is the fundamental geologic unit used for the assessment of undiscovered oil and gas resources. The Total Petroleum System is shown here as a geographic boundary defined and mapped by the geologist responsible for the province and incorporates not only the set of known or postulated oil and (or) gas accumulations, but also the geologic interpretation of the essential elements and processes within the petroleum system that relate to source, generation, migration, accumulation, and trapping of the discovered and undiscovered petroleum resource(s). The Total Petroleum System boundaries were defined in the...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 505001 = South Florida Basin Sunniland-Dollar Bay,
50500101 = Lower Cretaceous Shoal-Reef Oil,
505002 = South Florida Basin Pre-Punta Gorda,
50500201 = Pre-Punta Gorda Dolomite Gas and Oil Hypothetical,
Coalbed methane resources,
The depth to top of the Wilcox Group is contoured from location and top information derived from the Petroleum Information (PI) Wells database. The depth to Wilcox map represents the tops found in the database with the addition of surface geology from USGS maps and field data. The veracity of the PI Wells database is being checked by comparison to published cross sections and geologic maps. Interpretation of the depth to Wilcox and apparent thickness maps along with published measured sections and cross sections indicates that portions of Texas, Louisiana, Mississippi and Alabama contain broad areas where a 20 to 40 foot net thickness of lignite and coal occur at shallow depths. The thicker coal zones are attributed...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 47 = Western Gulf,
48 = East Texas Basin,
49 = Louisiana-Mississippi Salt Basins,
50 = Florida Peninsula,
AL,
This isopach map shows the thickness of the interval from the top of the Travis Peak or Hosston Formations to the top of the Cotton Valley Group. The map was produced by first subtracting the values of the top of the Travis Peak or Hosston from those of the top of the Cotton Valley Group. This resulted in a data set of 8,585 values for which locations were available. After deleting the wells with obvious data problems, a total of 8414 wells were used to generate the map. The data are provided as both lines and polygons, and the proprietary wells that penetrate this interval are graphically displayed as quarter-mile cells. The well information was initially retrieved from the IHS Energy Group, PI/Dwights PLUS Well...
This isopach map shows the thickness of the interval from the top of the Cotton Valley Group to the top of the Smackover Formation. It was necessary to contour this expanded interval, instead of just the upper part of the Cotton Valley Group, because of the limited availability of data. Ideally, just the part of the Cotton Valley Group above the Bossier Shale would have been contoured, but there are a limited number of Bossier picks in the database, and many of the Bossier picks are not at a consistent stratigraphic break (J.L. Ridgley, oral commun., 2002). Data for units below the Bossier, such as the Haynesville or Buckner Formations, are also limited on a regional basis. The Smackover Formation is the first unit...
The Assessment Unit is the fundamental unit used in the National Assessment Project for the assessment of undiscovered oil and gas resources. The Assessment Unit is defined within the context of the higher-level Total Petroleum System. The Assessment Unit is shown here as a geographic boundary interpreted, defined, and mapped by the geologist responsible for the province and incorporates a set of known or postulated oil and (or) gas accumulations sharing similar geologic, geographic, and temporal properties within the Total Petroleum System, such as source rock, timing, migration pathways, trapping mechanism, and hydrocarbon type. The Assessment Unit boundary is defined geologically as the limits of the geologic...
Categories: Data,
pre-SM502.8;
Types: Downloadable,
Map Service,
OGC WFS Layer,
OGC WMS Layer,
Shapefile;
Tags: 505001 = South Florida Basin Sunniland-Dollar Bay,
50500101 = Lower Cretaceous Shoal-Reef Oil,
505002 = South Florida Basin Pre-Punta Gorda,
50500201 = Pre-Punta Gorda Dolomite Gas and Oil Hypothetical,
Assessment Unit,
|
|
